In my previous post, I wrote about how simple it was to create containers with systemd-nspawn.
But what if you wanted to expose to the outside network to a container? The rest of the world can’t add mymachines to /etc/nsswitch.conf and expect it to work, right?
And what if you were trying to reduce the installed dependencies in an operating system using systemd?
Enter systemd-networkd and systemd-resolved…
Firstly, this Fedora 25 host is a kvm guest so I added a new network interface for “service” were I created the bridge (yes, with nmcli, why not learn it as well on the way?)
nmcli con add type bridge con-name Containers ifname Containers nmcli con add type ethernet con-name br-slave-1 ifname ens8 master Containers nmcli con up Containers
Then, in container test, I configured a rule to use DHCP (and left in a modicum of a template for static addresses, no… that’s not my network) and replaced /etc/resolve.conf with a symlink to the file systemd-resolved manages:
cat <<EOF > /etc/systemd/network/20-default.network [Match] Name=host0 [Network] DHCP=yes # or swap the above line by the lines below: #Address=192.168.10.100/24 #Gateway=192.168.10.1 #DNS=22.214.171.124 EOF rm /etc/resolv.conf ln -s /run/systemd/resolve/resolv.conf /etc/resolv.conf
Finally, I enabled and started networkd and resolved:
systemctl enable systemd-networkd systemctl enable systemd-resolved systemctl start systemd-networkd systemctl start systemd-resolved
A few seconds later…
-bash-4.3# ip addr list dev host0 2: host0@if29: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc noqueue state LOWERLAYERDOWN group default qlen 1000 link/ether 06:14:9c:9e:ac:ca brd ff:ff:ff:ff:ff:ff link-netnsid 0 inet 192.168.10.92/24 brd 192.168.10.255 scope global host0 valid_lft forever preferred_lft forever -bash-4.3# cat /etc/resolv.conf # This file is managed by systemd-resolved(8). Do not edit. # # This is a dynamic resolv.conf file for connecting local clients directly to # all known DNS servers. # # Third party programs must not access this file directly, but only through the # symlink at /etc/resolv.conf. To manage resolv.conf(5) in a different way, # replace this symlink by a static file or a different symlink. # # See systemd-resolved.service(8) for details about the supported modes of # operation for /etc/resolv.conf. nameserver 192.168.10.1